Aluminum Sheet For ACP Application

Aluminum-plastic composite panel with aluminum sheet Raw Material

Introduction to Aluminum Sheet Substrate for Aluminum-plastic Composite Panel

• Thickness: 0.1-500mm

• Width: 20-2650mm

• Typical alloys: 1100 aluminum sheet, 3003 aluminum sheet, 3004 aluminum sheet, etc.

• Material status: F, O, H12, H14, H16, H18, H19, H22, H24, H26, H28, H111, H112, H114

• Application areas: Aluminum-plastic composite panels, aluminum veneer panels, curtain wall panels, roofing panels, corrugated panels, and pressed tile panels, etc.

Aluminum-plastic composite panel specification using aluminum plate technology

Aluminum-plastic composite panels generally adopt a 4-6mm multi-layer composite structure, with both top and bottom layers made of high-purity aluminum plates with a thickness of 0.5mm, and a middle layer of PE or PVC sandwiched in between. A protective film is also attached to the front surface. Aluminum-plastic composite panels are a new type of building material, widely used in exterior wall decoration, signage, display panels, advertising boards, building partitions, and interior wall decorative panels.

The top and bottom plates of the aluminum-plastic composite panel are generally made of 1100 aluminum plate, 3003 aluminum plate, 3004 aluminum plate, etc.

Aluminum plate manufacturers suitable for aluminum-plastic composite panel

Gwangyang Aluminum only provides 1100 aluminum plate, 3003 aluminum plate, 3004 aluminum plate as the base material for aluminum-plastic composite panels and does not produce finished composite panels.

Aluminum substrate specification parameters for aluminum-plastic composite panels

Metal content standards for aluminum-plastic composite panel using aluminum plate substrate